Application Interface - Teledyne BOA Spot ID Series Quick Start Manual

BOA Spot Application Interface
The application interface has three panels. The left panel is for Instruction and Setup.
The large right panel is for displaying the Image and drawing tools. The bottom right
panel is for Configuration and displaying Status. The top right panel is the Navigation
bar.
Definition: Inspection job files are called "Solutions". You configure and save a
"Solution" to the BOA Spot memory. BOA Spot runs or switches between Solutions
stored in its memory. You can also export your Solutions to the client PC for backup.
Instruction
& Setup
The BOA Spot application will open to the "Select Solution" panel (shown above) if
there is no Solution currently running. The application opens to the "Run" panel if a
Solution is currently running. The run status is displayed at the top of the Instruction &
Setup panel.
• When you apply power to the BOA Spot, it will load and start running Solution0, if you
have "Auto Load" enabled, and if there is a Solution0 saved in the BOA Spot memory.
(You can also select which solution to auto-load via the web interface.)
• If there is no Solution0, or you do not have "Auto Load" enabled, BOA Spot opens to
the Select Solution panel and waits for you to load a Solution, or start a new Solution.
• If BOA Spot is running, it will continue running and inspecting when you close the
quit or application window. The application window runs on the PC only.
BOA Spot ID Quick Start
Navigation bar
Configuration & Status
43
Image
& Tool
Drawing
Version 1.2; 2017-11-20