Removing A 2.5 Inch Drive From The 3.5 Inch Drive Adapter - Dell EMC PowerEdge R340 Installation And Service Manual

Figure 28. Installing a drive into the drive carrier
Next steps
1. Install the drive carrier.
2. If removed, install the front

Removing a 2.5 inch drive from the 3.5 inch drive adapter

Prerequisites
1. Follow the safety guidelines listed in
2. If installed, remove the front
3. Remove the drive carrier.
4. Remove the drive adapter from the drive
Steps
1. Using a Phillips #1 screwdriver, remove the screws that secure the 2.5-inch drive to the 3.5-inch drive adapter.
2. Remove the drive from the 3.5-inch drive adapter.
bezel.
Safety instructions.
bezel.
carrier.
PowerEdge R340 installing and removing system components 51