Configuration Switch - Agilent Technologies 1260 Infinity G1315C User Manual

13
LAN Configuration

Configuration Switch

Configuration Switch

The configuration switch can be accessed at the rear of the module.
Figure 86
The module is shipped with all switches set to OFF, as shown above.
To perform any LAN configuration, SW1 and SW2 must be set to OFF.
N O T E
Table 28
Initialization ('Init') Mode
Link Configuration
264
Location of Configuration Switch
Factory Default Settings
Bootp, all switches down. For details see
mode selection"
speed and duplex mode determined by auto-negotiation, for
details see
on page 265
"Link configuration selection"
Agilent 1260 Infinity DAD and MWD User Manual
"Initialization
on page 272