Initialization Mode Selection - Agilent Technologies 1260 Infinity G1315C User Manual

Initialization mode selection

The following initialization (init) modes are selectable:
Table 29 Initialization Mode Switches
1
Requires firmware B.06.40 or above. Modules without LAN on board, see G1369C LAN Interface Card
Bootp
When the initialization mode Bootp is selected, the module tries to download
the parameters from a Bootp Server. The parameters obtained become the
active parameters immediately. They are not stored to the non-volatile
memory of the module. Therefore, the parameters are lost with the next power
cycle of the module.
Figure 87
Agilent 1260 Infinity DAD and MWD User Manual
SW 6 SW 7
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
Bootp (Principle)

Initialization mode selection

SW 8 Init Mode
OFF Bootp
ON Bootp & Store
OFF Using Stored
ON Using Default
OFF 1
DHCP
13
LAN Configuration
265