Setting The 8-Bit Configuration Switch - Agilent Technologies 1100 Series Reference Manual

Setting the 8-bit Configuration Switch

The 8-bit configuration switch is located next to the GPIB connector. Switch
settings provide configuration parameters for GPIB address, serial
communication protocol and instrument specific initialization procedures.
Factory setting is
shown for
compartment
Figure 41
.
Table 37
Mode Select
GPIB
RS-232C
Reserved
TEST/BOOT
Switches 1 and 2 define which set of parameters (for example, for GPIB,
RS-232C, and so on) will be changed. Once the change has been completed, the
instrument must be powered up again in order to store the values in the
non-volatile memory.
1100 Series TCC Reference Manual
column
8-bit Configuration Switch
8-bit Configuration Switch
1 2
0 0
0 1
1 0
1 1
Introduction to the Column Compartment
3 4 5
GPIB Address
Baudrate
Reserved
RSVD SYS
6 7 8
Data Parity
Bits
RSVD RSVD FC
6
157