Adding A Seca Measuring Device - Seca 103 Instructions For Use Manual

Adding a seca measuring device

Parameter
Device name
Timeout Clear patient
data
Timeout Transmisson
error
Identification mode
Confirm measurement
at device
Server address
Port
32 • /
seca connect 103 seca 452
The Add a device
software in the browser. Configure the parameters described in the following
text according to the conditions and requirements of your network and your
institution. QR codes are generated once entries have been made in the
dialog field.
1. Enter the following data for the seca measuring device:
Description
Designation of the seca measuring
device
After expiration of the timeout,
temporarily stored patient data is
discarded.
After expiration of the timeout, the
assumes that a
seca connect 103
transmission error has occurred.
Specify patient/user identification
Specify whether a measurement must
be confirmed on the seca measuring
device
Address of the
seca connect 103
server
GPX listening port over which a seca
measuring device should
communicate with the
seca connect 103
dialog window is automatically active when you open the
Recommended designation elements:
• seca model number
• Setup location
• Inventory number
• Connection type: WiFi/Ethernet
• Min: 5 s
• Max: 3600 s
• Min: 5 s
• Max: 60 s
The
seca connect 103
system twice. Error messages are issued after twice
the amount of time set here.
•
On_with_Barcodes_Patient_User
Scan patient ID and user ID
• On_with_Barcodes_Patient
•
On_without_Barcodes
currently no function
• (recommended): Measurement must be con-
yes
firmed using the "Confirm" button (may differ by
device) or with the scanner
• : Measurement is automatically sent to the EMR
no
system once a stable weight value (autohold) is
present
Enter the IP address of the server on which the
is installed.
seca connect 103
Enter a GPX listening port that was enabled in the
Configurator ➔
seca connect 103
seca connect 103
Values
attempts to reach the EMR
(recommended):
: only scan patient ID
: for future system upgrades,
Configuring