Seca 103 Instructions For Use Manual page 13

No. Control
1 Change device settings
2
Add a device
3
Device name
4
Timeout Clear patient data
5
Timeout Transmisson error
6
Identification mode
Confirm measurement at
7
device
8
Server address
9
Port
10 QR code for device settings
11 settings
WiFi
12 QR code for WiFi settings
13 save
14 delete device
Change settings for operating existing device
Define settings for new seca measuring device
Specify the designation of the seca measuring device
Specify the timeout after which temporarily saved patient data is
discarded.
Specify the timeout after which the
has been a communication error with the EMR system.
Specify patient/user identification
Specify whether a measurement must be confirmed on the seca
measuring device
Enter the address of the server on which the
installed
Enter port (GPX Listening Port) over which a seca measuring device
should communicate with the
Scan QR code: Transfer settings to seca measuring device or
interface module
Enter WiFi settings for seca measuring devices
Scan QR code: Transfer WiFi settings to seca measuring device or
interface module
seca 452
Save settings for the seca measuring device
Remove seca measuring device from the device list
Function
assumes that there
seca connect 103
seca connect 103
software
seca connect 103
English
software is
seca 452
Overview • 13