Table of Contents
Advertisement
OPC9000 series − Instruction manual v1.0
2.4 Environmental conditions
ATTENTION
Damage caused by heat!
If the device is exposed to sunlight or any other light or heat source, it can overheat and suffer
damage.
Do not expose the device to direct radiation by sunlight or any other light or heat source!
ATTENTION
Damage caused by heat!
If the device is installed in a panel, casing or similar, heat accumulation can occur.
Make sure that heat can be dissipated from the device.
ATTENTION
Damage caused by condensation!
If the temperature of the device is different to that of the environment in which it is located,
condensation can form.
Switch on the device only after it has acclimated to the ambient temperature.
The device must be operated under the environmental conditions specified in the technical data.
Failure to observe any one of these conditions will invalidate the warranty of the device. ADS-TEC
cannot be held liable for any damages arising from improper use and handling.
© ads-tec Industrial IT GmbH • Heinrich-Hertz-Str. 1 • 72622 Nürtingen • Germany
11
Advertisement
Table of Contents
