5: Connecting The Antennas (Aerials); 6: Connecting To The Network - Sony STR-DN1020 Operating Instructions Manual

5: Connecting the
antennas (aerials)
Before connecting the antennas (aerials), be
sure to disconnect the AC power cord (mains
lead).
FM wire antenna (aerial) (supplied)
AM loop antenna (aerial)
(supplied)
Notes
• To prevent noise pickup, keep the AM loop
antenna (aerial) away from the receiver and other
equipment.
• Be sure to fully extend the FM wire antenna
(aerial).
• After connecting the FM wire antenna (aerial),
keep it as horizontal as possible.
6: Connecting to the
network
Configuring your home network with DLNA-
compliant devices.
If your server (a computer, etc.) is connected to
the Internet, you can connect this receiver to
the Internet as well, through the wired LAN
connection.
Note
The method used to connect your server (a
computer, etc.) to the Internet depends on the
devices, your ISP, your server, and the router used.
System requirements
The following system environment is required
to use the Home Network, Music Services, and
PARTY STREAMING functions of the
receiver.
A Broadband line connection
A Broadband line connection to the Internet is
required in order to listen to Music Services
and to update the software of the receiver.
Modem
This is the device that is connected to the
broadband line to communicate with the
Internet. Some of these devices are integrated
with the router.
Router
• Use a router compatible with 100 Mbps or
greater transmission speeds to enjoy content
on your home network.
• We recommend that you use a router
equipped with the built-in DHCP (Dynamic
Host Configuration Protocol) server.
This function automatically assigns IP
addresses on the LAN.
continued
GB
33