Usb Device - Sony STR-DN1020 Operating Instructions Manual

Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• Keep the satellite radio antenna, away
from the speaker cords and the power cord
to avoid picking up noise.*
• The signal strength of the stations is too
weak with automatic tuning. Use direct
tuning.
• Make sure you set the tuning scale
correctly (when tuning in AM stations
with direct tuning) (page 56).
• No stations have been preset or the preset
stations have been cleared (when tuning
by scanning preset stations is used). Preset
the stations (page 56).
• Press AMP, then press DISPLAY
repeatedly on the remote control so that
the frequency appears on the display
panel.
The receiver cannot receive satellite
channels at all.*
• The receiving condition is not good. Move
the antenna to the place where the
condition is good.
• Check that you subscribed to the satellite
radio service you want (page 58).
RDS does not work.**
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.**
• The service may be temporarily out of
order. Contact the radio station and find
out whether they actually provide the
service in question.
* USA and Canada models only.
**Europe and Australia models only.
iPhone/iPod
The sound is distorted.
• Press MASTER VOL – or
remote control repeatedly.
• Set the "EQ" setting of the iPhone/iPod to
"Off" or "Flat".
The iPhone/iPod cannot be charged.
• Check that the receiver is turned on.
• Make sure the iPhone/iPod is connected
firmly.
The iPhone/iPod cannot be operated.
• Check that you have removed the protect
case of the iPhone/iPod.
• Depending on the contents of the iPhone/
iPod, it may take time to start playback.
• Disconnect the iPhone/iPod and connect
the iPhone/iPod again.
• You are using an unsupported iPhone/
iPod. See "Compatible iPod/iPhone
models" (page 49) for the supported
device types.
The ring volume of the iPhone does not
change.
• Adjust the ring volume using the controls
on the iPhone.

USB device

Are you using a supported USB
device?
• If you connect an unsupported USB
device, the following problems may occur.
See "Compatible USB devices" (page 52)
for the supported device types.
– The USB device is not recognized.
– File or folder names are not displayed
on this receiver.
– Playback is not possible.
– The sound skips.
– There is noise.
– A distorted sound is output.
2
– on the
continued
GB
119