7: Connecting The Ac Power Cord (Mains Lead); Preparing The Receiver; Initializing The Receiver - Sony STR-DN1020 Operating Instructions Manual

7: Connecting the AC
power cord (mains lead)
Connect the AC power cord (mains lead) to a
wall outlet.
AC power cord (mains lead)
Note
Be sure to turn the receiver on when the video and
audio signals of a playback equipment are being
output to a TV via the receiver. If the power supply
of the receiver is not turned on, neither video nor
audio signals will be transmitted.
GB
36
To the wall outlet

Preparing the Receiver

Initializing the receiver

Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to revert back to the factory default
settings.
Be sure to use the buttons on the receiver to
perform this operation.
?/1
1
Press ?/1 to turn off the
receiver.
2
Hold down ?/1 for 5 seconds.
The "CLEARING" appears on the
display panel for a while, then changes to
"CLEARED !".
Changes or adjustments made to the
settings are now reset to the defaults.