Using a bi-amplifier
The menu is displayed on the TV screen.
The Settings menu list appears on the TV
Select "Speaker", then press
Select "SP Pattern", then press
Select the appropriate speaker
pattern so that there are no
surround back speakers and
front high speakers, then press
Select "SB Assign", then press
Select "BI-AMP", then press
The same signals output from the
SPEAKERS FRONT A terminals can be
output from the SPEAKERS
SURROUND BACK/FRONT HIGH/
BI-AMP/FRONT B terminals.
To exit the menu
• Set the "SB Assign" to "BI-AMP" before you
perform Auto Calibration.
• If you set the "SB Assign" to "BI-AMP", the
speaker level and distance settings of the surround
back speakers and front high speakers become
invalid, and those of the front speakers are used.
You can enjoy images and sounds from the
equipment connected to the receiver in zone 2
other than the main zone. For example, you
can watch the DVD in the main zone and listen
to the CD in zone 2.
When using an IR repeater (not supplied), you
can operate both equipment in the main zone
and Sony receiver in zone 2 from zone 2.
To operate the receiver from
You can operate the receiver without pointing
the remote control towards the receiver if you
connect an IR repeater (not supplied) to the IR
Use an IR repeater when you install the
receiver in a place where signals from the
remote control cannot reach.