Parameter
Server Address
System Log Level
Step 3
Click Save.
4.1.2 Port
You can set the port parameters, including speed, duplex, flow control, and so on.
Step 1
Select Advanced > Configuration > Port.
The Port Configuration interface is displayed. See Figure 4-9.
Step 2
Set the parameters. See Table 4-4.
Parameter
Port
Link
Speed
Description
Input the IP address of the log server.
Select the system log lever, including:
Error
Warning
Notice
Informational
Figure 4-9
Port configuration
Table 4-4 Port parameter
Description
Display all the ports.
If the port link is displayed as green, it is connected
successfully. And if the port link is displayed as red, it is not
connected.
Including Current and Configured. In Current list, if it is
displayed as Down, the port is not connected, and if it is
displayed as a certain speed, the port is connected
successfully. In Configured list, you can set the speed from
the drop-down list.
Advanced Settings 13