Dahua PFS4218-16GT-190 Web Config Manual page 30

Trap packet is the packet that Agent proactively sends to NMP to report some emergent and
important events, for example, the manged device roots.
By default, Agent is allowed to send SNMP Trap packet.
Step 1 Select Advanced > Configuration > Security > SNMP > Trap.
The Trap interface is displayed. See Figure 4-26.
Step 2 Click Add New Entry in Trap Destination Configurations.
The SNMP Trap Configuration interface is displayed. See Figure 4-27.
Step 3 Set the parameters. See Table 4-6.
Parameter
Trap Config Name
Trap Mode
Trap Version
Trap Community
Trap Destination Address
Trap Destination Port
Figure 4-26
Figure 4-27 SNMP Trap configuration
Table 4-6 NMP Trap configuration parameter
Description
Input the Trap Config name.
Select Enabled or Disabled to enable or disable the function.
Three versions: SNMP v1, SNMP v2c, and SNMP v3.
Input the Trap community name.
Input the Trap destination address.
Input the port number of the target host.
Trap
Advanced Settings 23