Dahua PFS4218-16GT-190 Web Config Manual page 17

1) Click Add Interface.
A new record is added. See Figure 4-3.
2) Set the parameters. See Table 4-1.
Parameter
VLAN
IPv4
Step 3 Add IP route.
1) Click Add Route.
A new record is added. See Figure 4-4.
2) Set the parameters. See Table 4-2.
Parameter
Network
Mask Length
Gateway
Step 4 Click Save.
4.1.1.3 NTP
Enable NTP function, and the switch can synchronize with the network time automatically.。
Step 1 Select Advanced > Configuration > System > NTP.
NTP Configure interface is displayed. See Figure 4-5.
Figure 4-3
Table 4-1 VLAN interface
Sub-parameter
-
IP Address
Mask Length
Figure 4-4
Table 4-2 IP routes
Description
It is the destination address of the IP packet.
Mask length, with destination address, is to identify the IP address of
the destination host or the route. After logical AND between
destination address and network mask, you can get the IP address of
the destination host or the route.
The gateway IP address of the route.
VLAN interface
Description
Input VLAN number.
Set the IP address of the VLAN interface.
Set the mask length of the IP address.
IP routes
Advanced Settings 10