Dahua PFS4218-16GT-190 Web Config Manual page 44

VLAN Configuration
Step 1 Select Advanced > Configuration > Security > ARP Inspection > VLAN
Configuration.
The VLAN Configuration interface is displayed. See Figure 4-50.
Step 2 Click Add New Entry.
A new record is added. See Figure 4-51.
Step 3 Input the VLAN ID, and select the Log Type from the drop-down list.
Step 4 Click Save.
Static Table
The static table is manually configured and maintained. It will not ageing, and it will not be
covered by dynamic ARP table.
Static table can enhance the security performance of communicaiton. Static table can regulate
that only the specific MAC address can be used in communication between network devices,
and the attack packet can not modify the mapping between the IP address and the physical
address of the table. Communication between the device and the other device is protected.
Step 1 Select Advanced > Configuration > Security > ARP Inspection > Static Table.
The Static Table interface is displayed. See Figure 4-52.
Figure 4-50 VLAN mode configuration (1)
Figure 4-51 VLAN mode configuration (2)
Figure 4-52 Static table
Advanced Settings 37