Setup Example (2) Of 1-5V Input And Unit - YOKOGAWA mR10000 436101 User Manual

Setup Example (2) of 1-5V Input and unit

IM 04P01B01-02E
Setting the Input Range and Alarm on Measurement Channels
Setting Span Right
8.
Likewise, set Span_R to 450.0 and press the
Span_R= 450.0
-200.0/ 1370.0˚C
The Setting complete screen is displayed. When this screen is displayed, the
settings entered up to then are applied.
Finishing the Settings
9.
When Setting complete screen is displayed, do either of the following:
Press the key to set other channels.
To finish setting the input range, press the ESC key.
02-02 Channel
Setting complete
10.
Hold down the
Set channel 03 to 1 to 5V standard signal input and 0.0 to 500.0% scale. The scaling
range is –20000 to 30000. The scaling range is –20000 to 30000 excluding the decimal
point.
The measured values in the range of 0.0 to 500.0% are recorded in a width of 100 mm
on the chart paper.
1-5V standard signal
1V
(Span left)
1.000
(Scale left)
0.0%
100 mm
Entering Setting Mode
1.
Hold down the
Selecting the Range
2.
Press the key with Range shown on the screen.
Set=Range
Input range and
Selecting the Channel Range
3.
Press the key to set the first channel to 03 and then press the
First channel Last channel
CH=03-03
First channel 01-
4.
Likewise, set the last channel to 03 and then press the
* When the key,
the operation is reversed as when the respective key is pressed by itself.
MENU key for 3 seconds to return to Operation mode.
5V
(Span right)
5.000
(Scale right)
500.0%
Chart paper
key for 3 seconds to enter Setting mode.
MENU
Displays a description of the setup item.
key, or CHARACTER key is pressed while holding down the SHIFT key,
key.
Displays the selectable range of channels.
key.
key.
33