Installing/Replacing The Plotter Pen (Pen Model); Installing/Replacing The Ribbon Cassette (Dot Model) - YOKOGAWA mR10000 436101 User Manual

Installing/Replacing the Plotter Pen (Pen Model)

Installing/Replacing the Ribbon Cassette (Dot Model)

IM 04P01B01-02E
1.
Open the door.
If recording is in progress, press the
2.
Open the display and key panel section.
3.
Hold the plotter pen cartridge and pull it out from the pen holder.
4.
Remove the cap from the new plotter pen and insert the pen firmly into the pen
holder.
5.
Return the display and key panel section to its original position.
• Improper cassette insertion may cause the color to change or damage the ribbon.
• Do not apply upward force to the printer carriage. If you do, the carriage position
may be offset, and the recorder may not print correctly.
1.
Open the door.
If recording is in progress, press the
2.
Press the
FUNC
3.
Press the (
Func=R. exchange
4.
Press the (
CH UP
The printer carriage moves near the center position, and R. exchange = End is
displayed.
5.
Open the display and key panel section.
You can open the display and key panel section by holding the tab at the lower
left and pulling it toward you.
Note
If the recorder is OFF, hold the printer carrige and move it near the center position.
Printer carriage
* When the key or
reversed as when the respective key is pressed by itself.
RCD
CAUTION
RCD
key.
) key several times to display R.exchange.
DISP
) key.
key is pressed while holding down the SHIFT key, the operation is
Preparing to Record
key to stop the recording.
key to stop the recording.
29