Table of Contents
Advertisement
Setup Example (2) of 1-5V Input and unit
IM 04P02B01-02E
Setting the Input Range and Alarm on Measurement Channels
Setting Span Right
8.
Likewise, set Span right to 450.0 and press the
Span right= 450.0
-200.0/ 1370.0˚C
The Setting complete screen is displayed. When this screen is displayed, the
settings entered up to then are applied.
Finishing the Settings
9.
When Setting complete screen is displayed, do either of the following:
Press the
key to set other channels.
To finish setting the input range, press the ESC key.
02-02 Channel
Setting complete
10.
Hold down the
Set channel 03 to 1 to 5V standard signal input and 0.0 to 500.0% scale. The scaling
range is –20000 to 30000. The scaling range is –20000 to 30000 excluding the decimal
point.
The measured values in the range of 0.0 to 500.0% are recorded in a width of 180 mm
on the chart paper.
1-5V standard signal
1V
(Span left)
1.000
(Scale left)
0.0%
180 mm
Entering Setting Mode
1.
Hold down the
Selecting the Range
2.
Press the
key with Range shown on the screen.
Set=Range
Input range and record
Selecting the Channel Range
3.
Press the
key to set the first channel to 03 and then press the
First channel Last channel
CH=03-03
First channel 01-06
4.
Likewise, set the last channel to 03 and then press the
* When the
key or
reversed as when the respective key is pressed by itself.
MENU
key for 3 seconds to return to Operation mode.
5V
(Span right)
5.000
(Scale right)
500.0%
Chart paper
key for 3 seconds to enter Setting mode.
MENU
key is pressed while holding down the SHIFT key, the operation is
key.
Displays a description of the setup item.
Displays the selectable range of channels.
key.
key.
35
Advertisement
Table of Contents
