Perform An Ssd Update - HP 8924C Application Manual

5. Position the cursor on the Display field and select Data.
6. Ensure that the mobile station has registered with the Test Set.
7. Dial the desired phone number on the mobile station and press the SEND key on the

Perform an SSD Update

There are two methods that can be used to perform an SSD Update:
•
•
Performing an SSD 1. Ensure that the Test Set is in the active state.
Update on the Control
Channel
2. Connect the mobile station to the Test Set as shown in
3. Turn on the mobile station.
4. If the CALL CONTROL screen is not displayed, select CALL CNTL from the To
5. Position the cursor on the Display field and select Date.
6. Ensure that the Test Set has Initialized Call Processing with Authentication.
7. Select AUTHEN on the To Screen meun.The AUTHENTICATION screen will be dis-
8. Select RANDSSD_1 field. Enter a new, valid RANDSSD_1 value (6-digit hexadeci-
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amcproc.fb
Chapter 9, 264 Using the Analog Call Processing Subsystem
Using the CALL CONTROL Screen to test AMPS Authentication
Processing with Authentication"
tion.
mobile station's handset. The mobile station signals the Test Set on the reverse control
channel with an origination message which includes the dialed phone number, the mo-
bile station's MIN number and the mobile station's ESN. If the mobile station transmit-
ted properly on the reverse control channel, the message RECC Return will flash
momentarily in the upper right-hand corner of the CALL CONTROL screen and then
the mobile station's phone number, ESN, decoded SCM, and called phone number will
be displayed. The Test Set will then reconfigure itself to the voice channel assignments
set up in the Voice Channel Assignment section of the CALL CONTROL
screen. The Access annunciator will then light while the Test Set signals the mobile
station on the assigned voice channel. The Connect annunciator will light if the mo-
bile station properly signals the Test Set on the reverse voice channel. The mobile sta-
tion is now connected to the Test Set on the assigned voice channel. The Voice
Channel Assignment fields will be replace with appropriate information. If orig-
ination with authentication was successful, then "Origination w/Auth suc-
cessful" will be displayed in the upper right-hand portion of the CALL CONTROL
screen. If origination with authentication failed, then "Origination w/Auth
failed" will be displayed in the upper right-hand portion of the CAll CONTROL
Screen.
SSD Update on the Control Channel
SSD Update on the Voice Channel
Channel" on page 287 for information on how to activate the Test Set.
bile Station to the Test Set," on page
Screen menu. The CALL CONTROL screen will be displayed.
tialize Call Processing with Authentication" on page 294
register the mobile station and activate Authentication.
played.
mal).
See "Initialize Call
for information on how to register the mobile sta-
See "Turn On The Test Set's Control
Figure 2, "Connecting a Mo-
269.
for information on how to
See "Ini-
297