To View The Decoded Reverse Channel Words From A Mobile Station Release - HP 8924C Application Manual

To View the Decoded Reverse Channel Words from a Mobile Station Release

1. If not already done, condition the Test Set.
2. If not already done, configure the Test Set.
3. Connect the mobile station to the Test Set as shown in
4. Turn on the mobile station.
5. Ensure that the Test Set is in the Connect state.
6. Select CALL DATA under the To Screen menu. The CALL DATA screen will be
7. Select the Release field. The Test Set will signal the mobile station with a release or-
8. Select the Display Word field. A list of reverse channel words which can be dis-
NOTE: If a word is chosen which was not part of the decoded reverse channel's message stream,
all the fields will be blank when it is displayed.
Step 7 and step 8 in the above procedure can be reversed, that is, the desired word
can be selected first, then the mobile station can be released. If the release is
successful, the contents of each display word contained in the reverse control
channel's message stream will be updated when the decoding is complete.
The release does not have to happen while you are viewing the CALL DATA
screen. When the CALL DATA screen is viewed, the contents of the display
words will contain the decoded data from the last successful call processing
function (registration, origination, page, release, order).
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amcproc.fb
Chapter 9, 264 Using the Analog Call Processing Subsystem
Processing" on page 279 for further information.
for further information.
bile Station to the Test Set," on page
page 288 for information on how to bring a mobile station up on a voice channel.
displayed.
der. The mobile station will respond to the release order and cease transmission. The
Test Set will terminate transmission on the forward voice channel and the Connect
annunciator will turn off. The Test Set will then reconfigure itself for transmission on
the forward control channel, begin to transmit system parameter overhead messages
and the Active annunciator will light.
played will appear in a Choices: menu. Select the desired word from the list of choices.
The decoded contents for each of the fields in the selected word will be displayed in the
lower portion of the display.
Using the CALL DATA Screen
See "Conditioning the Test Set for Call
See "Configure the Test Set" on page 286
Figure 2, "Connecting a Mo-
269.
See "Page a Mobile Station" on
305