HP 8924C Application Manual page 312

Chapter 9, 264 Using the Analog Call Processing Subsystem
Using the CALL BIT Screen
312
7. Select the Handoff field. The Access
nals the mobile station with the handoff information. If the mobile responds properly,
it will stop transmitting on the current voice channel, switch to the new voice channel
assignment, and transpond the new SAT frequency assignment. When the Test Set de-
tects that this has happened the Connect
was successful. The left-hand fields in the Voice Channel Assignment section
will be updated with the new voice channel assignment information.
8. Select CALL BIT from the To Screen menu. The CALL BIT screen will be dis-
played.
9. Position the cursor on the Data Spec field and select Bits.
10. Select the Set Message field and select FVC V Msg.
11. Select the VMAC field in the FVC V Msg and set it to 101 (this corresponds to a mobile
station power level of 5 - reference EIA/TIA-553 Mobile Station - Land Station Com-
patibility Specification, September 1989, page 2-2, Table 2.1.2-1).
12. Select the Handoff field. The Access
nals the mobile station with the handoff information. If the mobile responds properly,
it will stop transmitting on the current voice channel, and start transmitting on the same
channel with a power level of 5 (note that the channel assignment and SAT assignment
were not modified in this example, the mobile station simply switched to the same
channel with the same SAT assignment). When the Test Set detects that this has hap-
annunciator
pened, the Connect
mobile station power level after the handoff should be power level 5.
13. Position the cursor on the Data Spec field and select Std.
annunciator
will light while the Test Set sig-
annunciator
is lit indicating that the handoff
annunciator
will light while the Test Set sig-
is lit indicating that the handoff was successful. The
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amcproc.fb