HP 8924C Application Manual page 64

Chapter 2, Setting Up a Call
Setting up a Call
MSUT-Originated Call
Manual Operation:
Enter any phone number on the MSUT's keypad
and press the SEND key.
After Send is pressed on the MSUT, the Access Probe annunciator on the Test Set, will light to indicate that the
mobile station sent an access probe sequence in an attempt to gain system access.
The Test Set's Connected annunciator will light indicating that the MSUT is in the "Mobile Station Control on
the Traffic Channel State."
If the Test Set's Answer Mode field is set to Manual, you must press the Test Set's ANS key to manually answer
the phone.
HP-IB Help:
HP-IB Syntax:
"CDMA:CALL:ANSW" !answers a call from the MSUT.
HP-IB Example:
64
Refer to
"MSUT-Terminated Call" on page 63
(This command is only necessary when the Test Set's
).
Manual
The following HP BASIC example
following call-processing events occur:
• Page Sent
• Alerting (not included as a front-panel display annunciator
• Connected
See "CDMA Status Register Group"
HP 8924C User's Guide.
"
uses service requests to detect when the
in the Status Reporting chapter of the
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amcall.fb
field is
Answer Mode