HP 8924C Application Manual page 63

11. Make a call.
The Test Set supports both
MSUT-originated
MSUT-Terminated Call
Manual Operation:
1. Press the Test Set's CALL key. (The phone will
not ring if you have selected a service option 2
or 9 call).
2. If the service option 1 or 32768 is selected,
press the SEND key on the MSUT's keypad to
connect the call.
3. Verify that the Connected annunciator is lit.
Optional: Speak into the phone to test voice
quality if service option 1 or 3768 is selected.
After the CALL key is pressed on the Test Set, the Page Sent annunciator will light to indicate that a paging
message was sent to the MSUT. The Access Probe annunciator will then light to indicate that the mobile
station transmitted an access probe sequence in an attempt to gain system access. The MSUT should ring if
the Traffic Data Mode is set to service option 1 or 32768.
The following CDMA Status Register Group bits monitor the call processing
HP-IB Help:
states:
•
•
•
•
HP-IB Syntax:
"CDMA:CALL:MAKE" !makes a call from the Test Set (mobile terminated).
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amcall.fb
MSUT-terminated
calls. Both types of calls are described below.
Page Sent (BCD 2)
Access Probe (BCD 1)
Alerting (BCD 16)
Connected (BCD 8)
Condition registers are implemented for these bits, allowing HP-IB operation to mirror
the way they work on the display.
Chapter 2, Setting Up a Call
(originated from the Test Set), or
CDMA CALL CONTROL
Call Status MS FER Report
Transmitting
Registering
Page Sent
Avg Power
Access Probe
Connected
Softer Handoff
MS ID
RF Channel MS FER Traffic
384
Report Data Mode Phone Num
5099214001
Interval Svc Opt 1
Register
5 frames Data Type
Softer
Echo
by # frames MS Database
Handoff
On/Off ESN
Echo Delay
Begin/End
2 Seconds
by # frames
Protocol
On/Off Sector A
Avg Power
IS-95A 5
Power
Power Zero
RF Chan Std
-75.0
MS AMPS
Setting up a Call
%
dBm
----
To Screen
CDMA
CALL CNTL
Analog
1234 RX TEST
Cnfig
PRNT CNFG
dBm/BW
63