Chapter 9, 264 Using the Analog Call Processing Subsystem
Using Manual (Front-Panel) Control
Using Manual (Front-Panel) Control
Connecting A Mobile Station
268
In order to use the Analog Call Processing Subsystem a mobile station must be
connected to the Test Set and be powered on.
Figure 2, "Connecting a Mobile Station to the Test Set," on page 269
example of connecting a mobile station to the Test Set. Many of today's small,
handheld mobile stations require special fixtures, available from the mobile
station manufacturer, to access the antenna, audio in and audio out on the mobile
station.
If any audio testing is to be done on the mobile station, the audio input
(microphone input) to the mobile station and the audio output (speaker output)
from the mobile station must be connected to the Test Set. If no audio testing is to
be done only the antenna needs to be connected to the Test Set.
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amcproc.fb
shows a typical