To View The Decoded Reverse Channel Words From A Mobile Station - HP 8924C Application Manual

Chapter 9, 264 Using the Analog Call Processing Subsystem
Using the CALL DATA Screen
To View the Decoded Reverse Channel Words from a Mobile Station Page
Viewing the Decoded
Reverse Channel
Words from a Page to a
Mobile Station that has
Registered with the Test
Set
NOTE:
302
There are two methods that can be used to view the decoded RVCC words from a
mobile station page:
• View the decoded RVCC words from a page for a mobile station that
with the Test Set
• View the decoded RVCC words from a page for a mobile station that
with the Test Set
1. If not already done, condition the Test Set.
Processing" on page 279
2. If not already done, ensure that the Test Set is properly configured.
Test Set" on page 293
3. Connect the mobile station to the Test Set as shown in
bile Station to the Test Set," on page
4. Turn on the mobile station.
5. If the CALL DATA screen is not displayed, select CALL DATA under the To Screen
menu. The CALL DATA screen will be displayed.
6. Select the Active field. The Active annunciator will light when the control channel
is turned on.
7. Ensure that the mobile station has registered with the Test Set.
Station" on page 287
8. Select the Page field. The Page annunciator will light while the Test Set pages the
mobile on the forward control channel. If the mobile station responds properly on the
reverse control channel, the message RECC Return will flash momentarily in the up-
per right-hand corner of the CALL CONTROL screen. The Access annunciator will
then light while the Test Set sends the mobile station an alert order on the assigned
voice channel. The mobile station should ring.
9. Press the SEND key on the mobile station. The Connect annunciator will light if the
mobile station properly signals the Test Set when the SEND key is pressed. The mobile
station is now connected to the Test Set on the assigned voice channel.
10. Select the Display Word field. A list of reverse channel words appears in a Choic-
es: menu. Select the desired word from the list of choices. The decoded contents for
each of the fields in the selected word will be displayed in the lower portion of the dis-
play.
If a word is chosen which was not part of the decoded reverse channel's message stream,
all the fields will be blank when it is displayed.
Steps 8 and 10 in the above procedure can be reversed, that is, the desired word
can be selected first, then the mobile station can be paged. If the page is
successful, the contents of each display word contained in the reverse control
channel's message stream will be updated when the decoding is complete.
See "Conditioning the Test Set for Call
for further information.
for further information.
269.
for information on how to register the mobile station.
N:\mkt\MANUALS\HP8924C\APPMOD\BOOK\chapters\amcproc.fb
has registered
has not registered
See "Configure the
Figure 2, "Connecting a Mo-
See "Register a Mobile