Hydraulic Oil - stertil-KONI SKY-200 Installation, Operation And Maintenance Instructions

Hydraulic vehicle lift
Table of Contents

Advertisement

7.3.2 Hydraulic oil

Replace the hydraulic oil in the tank about once every 2 years (see
Note
n
When the vehicle lift is not in constant use, this oil change must also be carried out.
To change the hydraulic oil, carry out the following procedure:
1.
Set the vehicle lift to the lowest position and drain off the oil.
2.
Fill the tank with hydraulic oil Unil HVC SX 15.
Alternative oils:
• Mobil DTE 10 Excel 15,
• Biological degradable oil Panolin SYNTH 15 (on customers request).
Note
n
The different types of oils should not be mixed.
3.
After draining the oil and refill the system with new oil, a low mix percentage is
allowed.
Note
n
However, warranty will expire when not prescribed oil is used and / or when different
types of oils are mixed.
Table 7.2 Hydraulic oil
Model
Capacity
Warning
w
Use only approved oil in the reservoir. An incompatible oil may damage or totally
destroy the seals of the hydraulic cylinders, pump, and valves. This could cause a
serious safety hazard.
Warning
w
Do not check or add oil when the lift is in the raised position. An overflow condition
may the result. Needless damage could occur to the lift components.
Operation & maintenance instructions (Version H)
SKY-200/250
20 gallon (75 liter)
64
Maintenance procedures
Table
7.2).
SKY-200/250

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sky-250

Table of Contents