Lighting Armatures (Option) - stertil-KONI SKY-200 Installation, Operation And Maintenance Instructions

7
• When pull bars and axles are mounted again and the hydraulic hose (including
extension) is connected, the leg can be lifted using the cylinder, until the bearing
blocks are resting against the track. To make this possible, open the emergency
lowering valves of the other 3 cylinders. The hydraulic pump can be activated by
activating the motor relay manually.
• In case of replacement of the cylinder at the side of the sliding bearings, the leg
can move from its original position into the slotted hole during mounting. This
results in misalignment of the holes in the bearing blocks and the track. This can
be corrected by moving the leg by means of a lever.
• When mounting the leg again, do not forget to remove the hydraulic hose
extension. Before removing the extension, rest the lift on the locking pawls to
make sure that there is no pressure on the hydraulic system.

7.3.4 Lighting armatures (option)

Note
n
Clean lighting only with a non-aggressive detergent.
Operation & maintenance instructions (Version H)
Inspection and maintenance
67 SKY-200/250