Table of Contents
Advertisement
6
The vehicle lift is operated by means of the control box.
Note
n
Only use finger tips to operate the control panel. Do not use sharp objects (such as
screwdrivers) to operate the control panel as this can cause damage and
breakdown.
The control buttons for lifting, lowering and unlocking are of the hold- to-run type.
This means that the function will be active as long as the push button is operated
and will stop as soon as it is released.
6.2
Switching-on
Switching on the vehicle lift is carried out as follows:
1.
Turn the main switch (1) to position 1.
This connects the mains power supply and the control voltage.
2.
The vehicle lift is now ready for use.
6.3
Raise
Press button (2) to raise the vehicle lift. There is an upward pointing arrow next to
this button.
Due to small height differences it is possible that the lift will not raise. This situation
can be recognized by a blinking <Mains power> indication (0,5 sec on, 0,5 sec off).
Note
n
A flashing light, 0.2 sec on, 0.8 sec off, indicates an internal failure.
The lift-stop function can be overruled for 2 seconds by operating the <overrule>
button and then the <lifting> button. If the height difference is still more than 1 9/16"
(40 mm), it is not possible to raise the lift with the lifting push button only. The before
mentioned operation can be repeated, until height differences are minimized by the
control system (blinking stops), and normal lifting is possible.
Note
n
During raising, the <unlock> button (4) can be pressed once. The safety pawls will
remain in the open position during the upward motion and will no longer make a
clicking sound. When the raise button is released, the safety pawls will engage
again.
Warning
w
If some of the lifting devices are still not lifting, they are overloaded. The before
mentioned operation will only cause greater height differences. The control system
will shut-off automatically.
Operation & maintenance instructions (Version H)
Operation
59
SKY-200/250
Advertisement
Table of Contents
