Maintenance Procedures; Lubrication Program; Hydraulic Oil - stertil-KONI ST 1082-FS Installation, Operation And Maintanance Instructions

For additional details, see chapter
Table 6.1 Lubrication program
Maintenance tasks
Cylinder
Check oil level in tank
Various pivot points
Hydraulic oil in the tank
Suction filter
Safety lock
Safety lock
6.3

Maintenance procedures

6.3.1 Lubrication program

The column lifts must be serviced regularly in accordance with the lubrication
program.

6.3.2 Hydraulic oil

Replace the hydraulic oil in the tank approximately once every 2 years.
Note
n
This oil change must take place as scheduled, even when the column lifts are not in
continuous use.
When changing the hydraulic oil, proceed as follows:
1. Fully lower the column lifts and drain off the oil.
2. Fill the tank with UNIL HVD S15 (ISO VG15) hydraulic oil filtered at maximum
4 microns. Quantity of hydraulic oil in the tank: 2.6 gallon.
Operating instructions (Version F)
7 "Service and troubleshooting" on page
Description
Lubricate piston rod if
dry (machine oil)
Top up (only with
column lifts fully
lowered)
Lubricate
Replace (2.6 gallons)
Clean or replace
Check and clean if
required
Disassemble, clean
and (if necessary)
replace and adjust
(see section 6.3.4)
44
Every 2
Annual
Monthly
(technical
service)
x
x
x
x
x
ST 1082 & ST 1100
47.
years
(technical
service)
x
x