Table of Contents
Advertisement
6
Operation
6.1
General
Before driving on, always put the lift in its lowest position to ensure minimal drive-
on height. In this situation a vehicle can be driven on to the lift.
Position the vehicle straight on the lift with the tires completely on the tracks. Engage
the handbrake and the block the wheels. Adjust the tracks only without load. The
tracks can be adjusted to meet the track width of the vehicle.
If the load (weight of the vehicle) it not correctly distributed to the front-end site or
rear-end site of the lift, the overload protection will be activated.
The lifting devices that are not overloaded will continue to raise but after a height
difference of 1 9/16" (40 mm), the "interrupt lifting" control system stops the raising.
If this is happening, lower the lift completely. After repositioning of the vehicle, it is
possible to raise the lift again.
1. (Emergency) main switch
2. Raise
3. Lower
4. Unlocking
5. Overrule
Note:
The option two speed lowering is not possible at tandem operation.
Figure 6.1 Control panel
Operation & maintenance instructions (Version H)
6. Mains power indicator
7. Track lighting on/off (optional)
8. Lowering speed switch (option)
or switch for coupled version
9. Acoustic alarm
58
6
SKY-200/250
Advertisement
Table of Contents
