Table of Contents
Advertisement
Operation
Head adjustment
A mechanical imprecision between the print head modules / cartridges by multi-head systems
can be compensated in this menu.
It is maximal +-1 – 2mm, which must be compensated.
A value from -50 to +50 can be entered to adjust the respective print head rightward or
leftward.
The respective print head goes rightward with a + value and leftward with a - value.
Conditions:
The print head must be installed horizontally. There may not be an overlap or gap between the
cartridges. It's the best to check this with a layout, which goes over all print heads.
The print speed must set up optimal. The nozzles A+B must be correct in one row by prints
with two nozzle rows. This can be checked with a loupe. There may not be a "shadow print".
Divider and intensity must be set up optimal by printing. The nozzles A+B must be correct in
one row by prints with two nozzle rows. This can be checked with a loupe. There may not be a
"shadow print".
Procedure:
1. Set all values for the head adjustment to „0".
2. I.e. by a quad head all values for head 1 will set to „0". Than a test print will made, which
goes over all print heads.
3. If there is a horizontally stowing between the first and the second print head module, it can
be compensated with the head adjustment of print head 2.
4. Proceed the same way with print head 3 and 4.
5. If there is a stowing after changing the cartridge, correct only the stowing of this cartridge.
1.
Touch the iLOGIK once in one of the status menus.
The Label submenu is displayed.
2.
Call the Parameter submenu by rotating the iLOGIK and select by pressing.
The Print Delay submenu is displayed.
3.
Call the Head adjustment submenu by rotating the iLOGIK and select by pressing.
The Head adjustment submenu is displayed.
4.
Make the desired setting by rotating the iLOGIK and select by pressing.
Seite 96 von 177
72800115 Markoprint X4JET
GB
Advertisement
Table of Contents
