Table of Contents
Advertisement
Operation
Print start delay
The print start delay can be set in this menu, i.e. by how much is printing delayed in
millimetres after the product is detected by the light barrier.
The delay can be selected between 0 and 999 millimetres.
About iDesign the operator can adjust the left or right edge of the print image as a
reference point for print position. The parameter can be set under button "System
Settings" tab "Advanced Settings" submenu "Extra configuration" menu
"Delay reverse print".
By this setting, potential problems are solved in reverse print. The left edge of a short
print image would be, under the mentioned conditions in Example 2, at another location
on the product, than the left edge of a longer print image, if no adjustment of the printing
position would be made. Example 3 shows, that no adjustment of the print position is
necessary, to print different long print images at the same position.
Example 1:
Product direction from right to left and the left edge of print image as reference
point.
Text12345
Delay
Text12
Delay
Example 2
Product direction from left to right and the right edge of print image as reference
point.
Text12345
Text12
Example 3:
Product direction from left to right and the left edge of print image as reference
point. (With calculation of the print start).
Text12345
Text12
Please note that the print start delay must be set up bigger than the text length.
If the print start delay is set up to small the print layout would be print complete. For
example: by a text length of 25 mm the set up of the delay between 0 and 25 mm has no
effect.
Delay
Delay
Delay
Delay
Seite 87 von 177
72800115 Markoprint X4JET
GB
Advertisement
Table of Contents
