Table of Contents
Advertisement
Installation and initial operation
Configuration of the print technology
The Markoprint X4JET can control the print technologies HP, LX and MX. The
Markoprint X4JET has two channels, which provide a combination of the different print
technologies.
After the system has been installed, the configuration of the print technologies is shown
and can set up with the first switch on ( Chapter Switch on / Switch off, page 76).
The configuration of the selectable print technologies is possible like shown in the
following list.
Configuration
of the
channels
1 – 2
HP – HP
HP – MX
MX – MX
MX – LX
LX – LX
LX - HP
The Markoprint X4JET control system is configured to HP – HP standard by the delivery
and can customize to the desired configuration if needed.
Requirements
The print system is correct installed.
The print system is connected to the power supply.
Instruction
Please adjust the configuration of the print technology as follows:
Step
1
2
3
Description
The system controls HP print head modules exclusively. Up to two print head
modules are selectable.
The system controls one HP print head module and one MX print head module.
The system controls MX print head modules exclusively. Up to two print head
modules are selectable.
The system controls one MX print head module and one LX print head module.
The system controls LX print head modules exclusively. Up to two print head
modules are selectable.
The system controls one LX print head module and one HP print head module.
Procedure
Switch the system on.
The display shows the company logo and changes to the configuration menu.
Set the desired print technology for channel 1 (Chan1) by rotating the iLOGIK
Seite 74 von 177
Chapter Switch on / Switch off, page 76
Fig. 0-5: Configuration menu print technology
72800115 Markoprint X4JET
GB
Advertisement
Table of Contents
