Table of Contents
Advertisement
Operation
To set the zoom
The width of the print image can be varied with the zoom value. At a zoom of 100%, the
print image is printed 1:1 as displayed in the iDesign.
With this parameter a change in the size of the print image is achieved. If the parameter
is reduced the print image becomes narrower by delaying individual pixel gaps. This
compresses the pint image and enables the ink consumption to be reduced.
By printing of barcodes you must look out for print optimal with 300 dpi and 100%.
Other dpi values or an enlarging or narrowing can cause deformations.
With the standard setting the print image has the same width, irrespective of the
modified intensity (dpi).
100% = 1:1
Via WEB-interface or iDesign it is possible to select the "Fixed zoom". The print image
will be print with all pixel, irrespective of the intensity.
The print image is in the width 1:1 with a resolution of 600 dpi.
With a resolution of 300 dpi, the print image is more than twice the width 1:2, caused of
the halved intensity.
Change the zoom to 10% - 900% with the iLOGIK. The value can be changed in 1%
steps.
Pay attention, that a widening or narrowing of barcode prints have the right measure.
Follow the chart!
Barcode width:
1
2
3
4
5
6
33
Allowed Zoom factors with fixed zoom:
50
33
66
25
50
75
40
60
80
50
66
83
Seite 93 von 177
100
200
300
100
150
200
100
133
166
100
125
150
100
120
140
100
116
133
72800115 Markoprint X4JET
400
500
600
250
300
350
200
233
266
175
200
225
160
180
200
150
166
183
...
...
...
...
...
...
GB
Advertisement
Table of Contents
