Smartcard Functionality - Weber Markoprint X4JET Manual For Installation, Operation And Maintenance

Table of Contents

Assembly and function

72800115 Markoprint X4JET

SmartCard Functionality

The Markoprint X4JET print system is equipped in the MK2 version with SmartCard identification

of the cartrigdes.

The MK2 printhead has an additional contact block which connects the SmartCard chip with the

analysis electronics by insertion of the SmartCard cartridge.

View of the SmartCard contacting

View of the SmartCard

cartridge

The chip is detected by inserting the cartridge. The LED at the head show this:

The LED blinks green for 3 seconds if the SmartCard is detected.

The LED blinks green/red if a cartridge without SmartCard is inserted. The system works without

the advantages of the SmartCard data.

If the print system isn't activating for the use of cartridges without SmartCard, the LED will be

blink red and the print system doesn't print.

The LED blinks yellow/red if there is a read error on the SmartCard chip and the cartridge prints

without consideration of the SmartCard data.

Seite 42 von 177

Table of Contents