Table of Contents
Advertisement
Operation
Print Stop:
One cartridge can be stopped to clean or change these.
The second cartridge takes the task of the first cartridge and prints on every product
from now on.
A print stop of both cartridges isn't possible for security reasons.
Otherwise, it can easily result misprints by misuse.
If the system should not be print for a time, although it is running, a print image without
data can be assigned.
Or the print can stopped via iDesign.
Ink warning:
If a cartridge displayed a „Ink warning", these stops printing and the other cartridge take
the print function over.
The output displayed „Warning".
After changing of the cartridge and reset of the ink level (only with HP) the print can start
again.
The ink level of LX print heads is reset automatically and the print can start directly.
The ink warning level can set up in % in iDesign.
If both cartridges are empty the output shows „Alarm"
Change cartridge:
A cartridge, which displays a warning, stops printing and goes into pause status.
The main menu shows the cartridge grey in the preview.
Now the cartridge can take out and will be replaced by a new one.
The ink level must be reset by a HP print head. Therefore select the corresponding head
and press the ink button.
Set the ink reset to "YES" and confirm with "OK". The ink level is by 100% now and the
print can be started again.
Seite 110 von 177
72800115 Markoprint X4JET
GB
Advertisement
Table of Contents
