Table of Contents
Advertisement
Transport, packaging and storage
Storage Trident print heads
Store the Trident print heads under following conditions:
When a print head with ink type ScanTrue II is stored or not used for more than six
months, ink deposits may form, which can result in the clogging of different nozzles.
In this case, fill the print head with fresh ink before using.
Procedure:
Leave the nozzle plate closed with the nozzle locking clamp!
Remove the feeder tube on the head and pump the old ink out of the ink supply
system
Then remove the return flow from the ink system and pump the old ink out of the
print head
Finally, rinse out the head and resume operation
Customers having replacement heads in storage should rotate them every three months.
In this way, the customer has a regular control over the functional integrity of his print
heads.
All print heads must be tested once before installation
Before storage of the Trident print heads the ink bottle must be taken out and stored
according the storage instructions given below ink bottles.
The print head must be closed with the nozzle clip and the air inlet of the ink system
must be closed with the plastic plug. Close the ink filler opening (bottle) with the screw
cap. See also Disassembly of the print head
Store the print heads under following conditions:
Do not store outdoors.
Keep dry and free of dust.
Do not expose to aggressive media.
Keep away from direct sunlight.
Avoid mechanical shock.
Storage temperature: 5°C to 45°C.
Relative humidity: maximum 60 %.
Seite 30 von 177
72800115 Markoprint X4JET
GB
Advertisement
Table of Contents
