Table of Contents
Advertisement
Installation and initial operation
4
5
6
If a system is false configured or should be reconfigured, the start display can be
reactivated for the configuration of the print technology.
Instruction
Please call up the print technology configuration as follows:
Step
1
2
3
4
5
6
and confirm by pressing.
Set the desired print technology for channel 2 (Chan2) by rotating the iLOGIK
and confirm by pressing.
The selection is on Ok? after the desired configuration. Set the value to Yes by
rotating the iLOGIK and confirm by pressing.
The system restarts and reboot in the adjusted configuration.
Procedure
Touch the iLOGIK once in one of the status menus.
The Label Submenu is displayed.
Call the System Submenu by rotating the iLOGIK.
The System Submenu is displayed.
Press the head selection-button [1] and the iLOGIk at the same time.
The display shows a waiting picture shortly and returns to the System
Submenu automatically.
Switch the system off.
Switch the system on.
Configure the system like described above.
Seite 75 von 177
Chapter Switch on / Switch off, page 76
Chapter Switch on / Switch off, page 76
72800115 Markoprint X4JET
GB
Advertisement
Table of Contents
