Table of Contents
Advertisement
User's Manual—Sonic Knife
3.4 Cables from Sonic Knife to the Printer
3.5 Connecting the Ultrasonic Power Supply
Classification: Avery Dennison - Public
1. The sonic knife requires an internal cable in the printer. This
internal cable receives the data cord from the sonic knife and
connects it to the proper board locations inside the printer. If
this internal cable is not installed, call service.
2. Connect the sonic knife cable to the receptacle on the printer
as shown in Figure 3.
Stacker
connector
1. Locate the ultrasonic power supply in a convenient location
near the sonic Knife.
2. Connect the coaxial converter cable from the ultrasonic stack
to the ultrasonic power supply by pressing the connector firmly
into the socket.
3. Connect the 37-pin D-shell connector to the 37-pin connector
on the rear of the power supply. Tighten the mounting screws
to secure the connector.
FIGURE 3
15
15
15
15
Printer
Sonic Knife
connector
Advertisement
Table of Contents
