Table of Contents
Advertisement
User's Manual—Sonic Knife
3.0
Installation
3.1 Preparing for the installation
3.1.1
3.1.2
3.1.3
Classification: Avery Dennison - Public
AC Power Line
NOTE: AVERY DENNISON requires that the minimum electrical service be 10
Amps @ 115VAC or 6 Amps @ 230VAC. This will allow the printer, Sonic
Knife, and any additional support or service equipment to be plugged into
the same service. It is highly recommended that the printer and its
accessories be on a dedicated circuit.
The electrical service should meet standard electrical code practices, including
proper grounding and neutrals.
Location Considerations
The Sonic Knife weighs about 25 pounds (12 kg), and the power supply weighs
12 pounds (6 kg). The Sonic Knife with printer weighs 80 pounds (43 kg). This
equipment combination requires a table of sufficient quality and strength to
handle this load.
Locate the sonic knife in an area so that the cutting noise emitted from the knife
operation will not affect others. While AVERY DENNISON strives to keep the
sonic knife noise to the lowest level, it is not recommended for an office
environment.
The power source of the sonic knife should be a dedicated line. Signs appear
when power is not sufficient. In this case, the ultrasonic action will stop cutting
but the rest of the sonic knife will appear fully functional.
CAUTION: Each customer must take responsibility to ensure the
workstation created for the system meets the recommended
requirements to ensure optimal operation.
User Safety
1. Follow all of the safety requirements and procedures established for your
facility.
2. Turn off the power to the printer and sonic knife before cleaning, servicing, or
replacing any components.
3. You do not have to turn off the power when loading or changing supplies.
11
11
11
11
Advertisement
Table of Contents
