Table of Contents
Advertisement
32
6.4 Proximity Switch Adjustment
Classification: Avery Dennison - Public
0.015" gap
8. Retighten the ½" locking nut using the ½" wrench and 9/16 flat
wrench.
9. Re-install the covers.
The proximity switch triggers the power supply to begin generating energy during
the cut. If the proximity switch is not adjusted properly, the power supply will not
be triggered and the unit will not cut properly
Adjust the proximity sensor flag so that it is horizontal when the knife is in the
home (all the way up) position.
1. Remove the top cover.
2. Position the knife in the home position which is all the way up.
3. Loosen the collar of the proximity sensor flag with a 1/8" hex key and
position so that it is in a horizontal position as show in Figure17.
User's Manual—Sonic Knife
FIGURE 16
There are hazardous moving parts
in the printer. Covers must be in
place when energized. Service
should be performed only by
trained service personnel.
Advertisement
Table of Contents
