Table of Contents
Advertisement
User's Manual—Sonic Knife
6.6 Lifter Bracket / Adjustment
To adjust lifter bracket:
Classification: Avery Dennison - Public
1. Remove both
front and rear
sonic knife
covers.
2. Adjust cam to
Top Dead
Center (TDC)
position as
shown in figure
20 by rotating
cam until flag
is centered in
C sensor block.
3. Loosen screws shown in figure 21.
4. Place .020" thick feeler gauge between lift bracket and cam bearing.
5. Adjust gap on lift bracket to sandwich feeler gauge between bracket and
bearing and tighten screws from step 3.
6. Replace front and rear cover.
FIGURE 20
35
35
35
35
FIGURE 21
Advertisement
Table of Contents
