Repacking; Disassembly And Disposal; Storing Sonic Knife When Not In Use; Installing The Sonic Knife To The Printer - Avery Dennison SONIC Knife Operator's And Service Manual

User's Manual—Sonic Knife
3.2.2
3.2.3
3.2.4

3.3 Installing the Sonic Knife to the Printer

Classification: Avery Dennison - Public
6: Set the sonic knife on its back cover (the same position as it sits in
the carton).
7: Remove the tool bag, machine manual and power cord.

Repacking

Follow procedure in reverse order. It is required to band the package
with straps due to the tray carton design.

Disassembly and Disposal

1. No special steps are needed to decommission the printer.
2. Disconnect the Sonic Knife from the printer and remove it from
the printer
3. Dispose of the Sonic Knife in accordance with local laws and
ordinances.

Storing Sonic Knife When Not In Use

If the sonic knife is removed from the printer care should be taken that

it's stored in a safe location and manner to prevent it from falling or
tipping over causing personal injury or damage to the unit.
The sonic knife has a support bracket that can be extended on the

base of the printer to keep the unit upright.
If the sonic knife is stored in a busy work area or a bench that is not

stable it should be laid on its back for greater stability.
1. Locate the two mount posts on the printer used to hold the stacker.
2. Place the sonic knife in front of and to the right of the printer. Position the
knife so that the support bracket on the sonic knife aligns with the bottom
stacker support post as shown in Figure 2. The sonic knife is not free-
standing to keep positive control over the knife until it is securely installed
on the printer.
13 13 13 13