Avery Dennison SONIC Knife Operator's And Service Manual page 14

14
Sonic knife mounting
bracket
Classification: Avery Dennison - Public
3. Slide the sonic knife onto the bottom post and move the sonic knife back
until it is aligned with the printer.
4. Adjust the sonic knife forward/backward so the stock coming from the
printer is centered on the horn face.
5. Install the printer stacker on the stacker posts on the sonic knife. Those
posts mimic the printer stacker posts and installation of the stacker is the
same.
6. Plug the stacker into the stacker receptacle on the printer. If the stacker
power cord does not reach, check the position of the sonic knife.
User's Manual—Sonic Knife
FIGURE 2
Stacker
posts on
sonic knife