Table of Contents
Advertisement
16
Classification: Avery Dennison - Public
4. Connect the large D-shell connector to the connector installed
in the printer (step 1). Tighten the mounting screws to secure
the connector.
5. Connect the power cord to the ultrasonic power supply and the
AC power source.
NOTE: The 230v power supply has no AC (mains) power switch. Plugging it
in energizes it. Ultrasonic energy is generated only while cutting.
AC Power
Cable
37 pin
Connector
WARNING: Locate the Ultrasonic Power Supply in a location where it will
not be bumped or knocked over
User's Manual—Sonic Knife
FIGURE 4
Coaxial
Converter
Cable
Advertisement
Table of Contents
