Table of Contents
Advertisement
User's Manual—Sonic Knife
4.3 Ultra Sonic Horn "Stack"
4.4 Threading stock through the sonic knife
Classification: Avery Dennison - Public
If necessary, the factory settings may be restored as follows:
AUTO/MAN switch
CUTTING CONTROL
US-TIME
The "Converter / Horn" assembly is called the "Stack".
WARNING: Touching the horn during operation can cause burns.
The sonic knife has been set-up at the factory to run a checkout stock
as the minimum checkout requirement.
For information about supply compatibility or environmental
information, contact your local Avery Dennison Customer
1. Ensure the snubber brake is in the "up" position as shown in Figure 6.
This is the usual position when the knife is stopped. If the snubber
brake is not in the "up" position, press start and stop, to cycle the
system for one label.
AUTO
0
0
CAUTION: Each customer must take responsibility
to ensure the workstation created for the printer
meets the recommended requirements to ensure
optimal operation of the printer.
Service.
21
21
21
21
Advertisement
Table of Contents
