User's Manual—Sonic Knife
6.2 Leveling the Knife Blade
Classification: Avery Dennison - Public
CAM Advance Screw
9/64 Hex
drive
1. Remove the Knife Guard Cover.
2. Loosen the two knife screws.
"
3. Using a 9/64
wrench, advance the roller cam until the knife blade
assembly compresses against the Horn Surface.
4. Make sure the knife spring is fully compressed.
5. Tighten the two knife screws.
"
6. Using the 9/64
wrench, advance the roller cam back up to its original
home position.
There are hazardous moving parts
in the printer. Covers must be in
place when energized. Service
should be performed only by
trained service personnel.
FIGURE 10
27
27
27
27
Knife Guard
Cover, exit
conveyor, and
stacker removed