Arm And Disarm The System; Area System Type; All/Perimeter System Type; End User Training - DMP Electronics 7000INT Series Installation And Programming Manual

This section contains instructions on how users can arm and disarm their system, use
access control, and the entry delay feature, if programmed. All of the examples displayed
assume that CLOSING CODE is YES in panel programming.

ARM AND DISARM THE SYSTEM

Area System Type

1. Press CMD until the keypad displays ARM DISARM.
2. Press the select key under the preferred option.
3. If arming, the keypad displays ALL? NO YES. Select NO to arm individual areas.
Select YES to arm all areas. If disarming, the keypad displays ENTER CODE: -. The
user can either enter their user code or present their credential to the proximity
reader. Once validated by the system, all areas assigned to that code or credential
disarm automatically

All/Perimeter System Type

Press CMD until ARM DISARM displays. If arming, press ARM. Select ALL to arm all
areas or PERIM to arm only the perimeter. At ENTER CODE: -, enter a user code at the
keypad or present a credential to the proximity reader. If disarming, select DISARM. At
ENTER CODE: -, enter a user code at the keypad or present a credential to the proximity
reader.
27

END USER TRAINING

Digital Monitoring Products, Inc | 7000INT Series Installation and Programming Guide