hilscher NIOT-E-TPI51-EN-RE User Manual page 158

Examples for Node-RED
16. Returning to Node-RED:
17. Entering names:
18. Selecting a signal:
19. Finishing the fieldbus input node:
20. Connecting the nodes:
21. Deploy:
Edge Gateway | NIOT-E-TPI51-EN-RE (Connect)
DOC170502UM07EN | Revision 7 | English | 2019-07 | Released | Public
Ø Return to the tab Node-RED in your browser.
Ø To adopt a new/changed PROFINET configuration, click Reconfigure
interface.
Ø To add a new fieldbus interface, click Add
- or -
/>Update is offered as an alternative. Click Update, if only signal
names have been extended or changed, whereas the PROFINET
configuration has remained unchanged.
Ê The display returns to the edit dialog.
Ø Under Name enter a node name, e.g. MyOutput.
Ø Use
to open the signal list and select a Signal e.g.
output~toController~Temperature_2.
If the signal is not displayed, close the edit dialog with Done and
double-click to reopen the fieldbus node.
Ø Click Done.
ð The configuration of the fieldbus input node is completed, but not yet
activated in the Edge Gateway.
Ø To connect the first Inject node with the fieldbus output node, hold down
the left mouse button and draw a connecting line (wire) from the output
port of the Inject node to the input port of the fieldbus node.
Ø Connect the second Inject node with the fieldbus output node.
Ê The nodes are connected.
Ø Click Deploy to transmit the nodes, that have so far existed in the editor
only, to the device and activate them.
ð The flow is activated in the Edge Gateway.
158/294
© Hilscher 2017 – 2019